I have same setup with some changes - be mindful that unless you can clock your infinity fabric high enough you're introducing a ratio between the cpu and ram, what this means is that you could enable DOCP and then choose a lower clock speed (say 3600mhz) and tighten the timings, I think the max speed for general 1:1 with infinity is 3733mhz ram and 1866mhz fclk. INNO3D GEFORCE RTX 2070 Super iCHILL Frostbite What could be the issue or what can I do to get more safe speed? The settings are enlisted on the picture but all of them are set by auto except DRAM Voltage (1.3 instead 1.2). I cut the Power manually to get a safe boot and reset the settings. I tried to use the D.O.C.P (it based on the true settings from the Ram and save the BIOS settings, the Mainboard runs in an endless Loop with Start and Restart (2-3 Seconds after Power-Up then Power-Out and the game repeats itself). My next try was to use the BIOS settings (without auto oc) based on the TPU settings. My first try with the ASUS Crosshair Formula VIII and the 3900X with outo oc (called TPU I and II in BIOS) was successful with 4200 stable but with lesser RAM Frequency than -> about 2000. I got some strange issues which I cannot explain.
0 Comments
Leave a Reply. |